There are many types of seals, typically O-rings or skeleton oil seals; these are seals that are often used in machinery and equipment, and there is another type of seal that is often used, that is, sealing gaskets. The material of the gasket can be made of paper, rubber sheet or copper sheet, placed between two planes to strengthen the sealing ability of the material, in order to prevent leakage, it must be placed between the static sealing surface of the sealing element.

Our company uses laser cleaning 120W equipment to clean the surface of the metal gasket. By irradiating the laser beam, it is peeled off from the metal to achieve the cleaning effect. It can be seen that the metal gasket is covered with stains before cleaning. After laser cleaning, the surface of the gasket is as bright as new, and the oil, dust, etc. on it have been cleaned. The small holes on the metal gasket can also be cleaned. The comparison between before and after cleaning is also very obvious.

Laser cleaning has the following advantages:

1. Green cleaning: without the use of any chemicals, the cleaned waste is solid and harmless powder, which can completely solve the problem of environmental pollution caused by chemical cleaning.

2. Non-destructive cleaning: non-abrasive, non-contact, and no damage to the substrate during cleaning.

3. Low-cost cleaning: The equipment consumes very little power during operation.

4. Precision and precision cleaning: It is possible to perform precision and precision cleaning on designated areas.

5. Automated cleaning: It can be equipped with automated equipment to achieve automated cleaning.

With the increasing awareness of environmental protection and safety, laser cleaning is widely used due to its non-grinding, non-contact, non-thermal effect and suitability for objects of various materials. At the same time, laser cleaning can solve problems that cannot be solved by traditional cleaning methods.